Ir al contenido

Tectyl™ 4D750

Referencia TECTYL-4D750
Precio bajo consulta

Confirma formato, cantidad y aplicación con nuestro equipo técnico.

Consultar precio y disponibilidad
Términos y condiciones
Grantía de devolución de 30 días
Envío: 2-3 días laborables

Información técnica y de seguridad

Producto químico
Base portadora
Otro
Base química
Resina y aceite
Color
Amarillo claro
Presentación
Consultar formatos disponibles
Pedido mínimo
Consultar

Etiquetado y seguridad

Revisión de la FDS: GHS 3.1 — 23.03.2026

Esta mezcla no requiere elementos de etiqueta CLP según la FDS vigente.

Información suplementaria

  • EUH208: Contiene Fatty acids, C6-19-branched, cobalt(2+) salts. Puede provocar una reacción alérgica.
  • EUH210: Puede solicitarse la ficha de datos de seguridad.

Tectyl 4D750 is a resin/oil based, light yellow, liquid corrosion preventive compound. Tectyl 4D750 is formulated with a minimum of volatile organic components. Tectyl 4D750 is designed for industrial application giving good penetration into folds, flanges and cracks, making it very suitable as a corrosion protective for the inside of car doors and other hollow sections of cars and rolling equipment. Tectyl 4D750 cures to a light yellow, translucent, semi-soft film.

Benefits and application considerations

  • Superior Protection At the recommended DFT, the product provides extraordinary protection in the hollow sections against corrosion.
  • Efficient With a DFT of only 50 microns, Tectyl 4D750 is an efficient corrosion protection, protecting a large area with little amount of the product.

Technical characteristics

Carrier
Non Solvent
Recommended Dry Film Thickness — Over metal profile
50 µm
Corrosion — ISO 9227 NSS (min. days)
15 days
Humidity — Humidity; 100 % RH; @ 40°C; ISO 6270-2 CH (Q-Panels, Type R, ASTM A1008)
50 days
Protection Indoor — (min. months)
60 months
SFS 4086: 2006
Pass

Surface preparation

The maximum performance of Tectyl 4D750 can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale. CorPro recommends a substrate temperature of 10-35 °C at the time of product application.

Application

Tectyl 4D750 is formulated to be used as supplied. CorPro recommends that the ambient and product temperature be 10-35 °C at the time of product application. Do not thin Tectyl 4D750. Tectyl 4D750 can be applied by low pressure air spray application. Details on application can be found in the application chart.

As Tectyl 4D750 is a chemical drying product, care should be taken to avoid prolonged contact of the product in the container with air (oxygen) as much as possible. During use this can be achieved by binding the plastic innerliner around the suction tube with a plastic binder. If not in use, keep the container tightly closed.

Removal

Tectyl 4D750 can be removed in the wet phase with Tectyl Biocleaner, Tectyl 150 or low-pressure steam. If dried and cured Tectyl 4D750 can be removed with Tectyl 150 or Tectyl Biocleaner.

Check the current official Technical Data Sheet and Safety Data Sheet before purchase or use. Coapsys can advise on product selection and application equipment.