Información técnica y de seguridad
- Base portadora
- Disolvente
- Base química
- Grasa
- Presentación
- Available formats on request
- Pedido mínimo
- Consultar
Etiquetado y seguridad
Revisión de la FDS: GHS 2.0 — 16.11.2025
Palabra de advertencia: Peligro
Indicaciones de peligro
- H226: Líquidos y vapores inflamables.
- H304: Puede ser mortal en caso de ingestión y penetración en las vías respiratorias.
- H336: Puede provocar somnolencia o vértigo.
Consejos de prudencia
- P210: Mantener alejado del calor, de superficies calientes, de chispas, de llamas abiertas y de cualquier otra fuente de ignición. No fumar.
- P261: Evitar respirar la niebla/los vapores.
- P301+P310: EN CASO DE INGESTIÓN: Llamar inmediatamente a un CENTRO DE TOXICOLOGĺA/médico.
- P303+P361+P353: EN CASO DE CONTACTO CON LA PIEL (o el pelo): Quitar inmediatamente toda la ropa contaminada. Enjuagar la piel con agua.
- P331: NO provocar el vómito.
- P370+P378: En caso de incendio: Utilice arena seca, polvo extintor o espuma resistente al alcohol para extinguir.
- P403+P233: Almacenar en un lugar bien ventilado. Mantener el recipiente cerrado herméticamente.
Información suplementaria
- EUH066: La exposición repetida puede provocar sequedad o formación de grietas en la piel.
Documentación
Ficha técnica en español Ficha de datos de seguridadLas fichas técnicas se sirven desde Coapsys y se obtienen de la fuente oficial Tectyl Europe.
Tectyl 150 can be used to remove cured Tectyl solvent based coating (after storage or shipment) from the protected object/substrate. Tectyl 150 can be used to remove uncured Tectyl solvent based coatings. Tectyl 150 can also be used as a degreaser for other purposes.
Benefits and application considerations
- Excellent performance Tectyl 150 gives an excellent clean surface coating and is highly economical in use.
- Easy to use Tectyl 150 is an easy-to-use product, which removes most solvent based Tectyl
- Easy to apply Application can be done with a brush or cloth in case of small areas.
- End result Tectyl 150 leaves a clean and grease free substrate.
Technical characteristics
- Carrier
- Solvent
- Protection Indoor — (min. months)
- n.a
- Protection Outdoor — (min. months)
- n.a
Surface preparation
CorPro recommends a substrate temperature of 10 – 35 °C at the time of product application.
Application
Tectyl 150 is formulated to be used as supplied. Stirring is generally not required. Application should take place in a well ventilated area.
Tectyl 150 can be applied by spraying with a spray gun or by cloth in case of small areas. Let the product work for approximately 3 – 6 minutes before removing Tectyl 150 off by high pressure water, preferably hot water or steam, leaving a clean surface.
Check the current official Technical Data Sheet and Safety Data Sheet before purchase or use. Coapsys can advise on product selection and application equipment.