Technical and safety information
Online Tectyl checkout is currently configured for Spain. For deliveries elsewhere in Europe, contact Coapsys to confirm availability and shipping before ordering.
- Carrier
- Water
- Chemical base
- Base acuosa
- Colour
- Transparente
- Pack format
- Consultar formatos disponibles
- Minimum order
- Consultar
For current hazard statements, precautions and transport information, consult the official English Safety Data Sheet before purchase or use. This page is not a substitute for the product label.
Documents
Technical Data Sheet (English) Application guide Safety Data Sheet (English)Technical documents are served by Coapsys from the official Tectyl Europe source.
TECTYL 3217 E has been specially designed for use as an environmentally friendly protector of unfinished metal and industrial finishes. The dry film is tack free and prevents dust build up. TECTYL 3217 E is excellent for use on aluminum and galvanized surfaces as protector. Eliminates water spotting caused by acidic rain or hard water. TECTYL 3217 E cures to a transparent, resilient, firm film.
Benefits and application considerations
- Superior protection Tectyl 3217 E is an excellent preservative for the storage or transit protection of finished and unfinished automotive parts.
- Environment Tectyl 3217 E is a water-based product with low VOC content.
- Easy application Due to the viscosity Tectyl 3217 E is easy to apply and forms excellent film formation at suitable layer thickness for highest efficiency.
- Fast drying With a dry to touch time of 30-60 minutes and a cure time of 8 hours Tectyl 3217 E is a fast-drying protective coating.
Technical characteristics
- Carrier
- Water
- Recommended Dry Film Thickness — Over metal profile
- 50 µm
- Corrosion — ISO 9227 NSS (min. days)
- 21 days
- Humidity — Humidity; 100 % RH; @ 40°C; ISO 6270-2 CH (Q-Panels, Type R, ASTM A1008)
- 100 days
- Protection Indoor — (min. months)
- 36 months
- Protection Outdoor — (min. months)
- 12 months
Surface preparation
The maximum performance of Tectyl 3217 E can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale. CorPro recommends a substrate temperature of 10-35 °C at the time of product application.
Application
Tectyl 3217 E is formulated to be used as supplied. CorPro recommends that the ambient and product temperature be 10-35 °C at the time of product application. Always ensure uniform consistency prior to use. Avoid contamination with other products in pumps and lines. CorPro recommends that the ambient and product temperature be 10-35 °C at the time of product application. For application Tectyl 3217 E CorPro recommends a low pressure airspray application or airless application with a small airless nozzle. Details on application can be found in the application chart.
Removal
Tectyl 3217 E is not intended for removal.
In the wet phase Tectyl 3217 E can be removed with water or with Tectyl Biocleaner. If dried and cured Tectyl 3217 E can be removed with ethyl acetate.
Check the current official Technical Data Sheet and Safety Data Sheet before purchase or use. Coapsys can advise on product selection and application equipment.