Technical and safety information
Online Tectyl checkout is currently configured for Spain. For deliveries elsewhere in Europe, contact Coapsys to confirm availability and shipping before ordering.
- Carrier
- Solvent
- Chemical base
- Según ficha técnica oficial
- Colour
- Ámbar
- Pack format
- Consultar formatos disponibles
- Minimum order
- Consultar
For current hazard statements, precautions and transport information, consult the official English Safety Data Sheet before purchase or use. This page is not a substitute for the product label.
Documents
Technical Data Sheet (English) Application guide Safety Data Sheet (English)Technical documents are served by Coapsys from the official Tectyl Europe source.
Tectyl™ 550-ML is a solvent-based, wax-based corrosion protection. Tectyl™ 550-ML has good water-displacing properties and good penetration, making it very suitable as corrosion protection for the inside of car doors and other hollow profiles of cars and other vehicles. Tectyl™ 550-ML cures to an amber-colored, waxy, semi-solid, translucent film.
Benefits and application considerations
- Superior Protection Tectyl 550-ML will protect against corrosion and will displace water where needed.
- Strong penetration With its strong penetration, Tectyl 550-ML will protect the surface against corrosion, even in small seams and crevices.
Technical characteristics
- Carrier
- Solvent
- Recommended Dry Film Thickness — Over metal profile
- 50 µm
- Corrosion — ISO 9227 NSS (min. days)
- 21 days
- Humidity — ISO 6270-2 CH (min. days)
- 75 days
- Protection Indoor — (min. months)
- 24 months
Surface preparation
The maximum performance of Tectyl 550-ML can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale. CorPro recommends a substrate temperature of 10-35 °C at the time of product application.
Application
Tectyl 550-ML is formulated to be used as supplied. Do not thin Tectyl 550-ML. CorPro recommends that the ambient and product temperature be 10-35 °C at the time of product application. Tectyl 550-ML can be applied by low pressure air spray or dipping. Details on application can be found in the application chart.
Removal
Tectyl 550-ML can in the wet phase be removed with Tectyl Biocleaner, Tectyl 150 or low-pressure steam. If dried and cured Tectyl 550-ML can be removed with Tectyl Biocleaner or Tectyl 150.
Check the current official Technical Data Sheet and Safety Data Sheet before purchase or use. Coapsys can advise on product selection and application equipment.