Technical and safety information
- Carrier
- Solvent
- Chemical base
- Cera y asfalto
- Colour
- Bronce
- Pack format
- Consultar formatos disponibles
- Minimum order
- Consultar
For current hazard statements, precautions and transport information, consult the official English Safety Data Sheet before purchase or use. This page is not a substitute for the product label.
Documents
Technical Data Sheet (English) Safety Data Sheet (English)Technical documents are served by Coapsys from the official Tectyl Europe source.
Tectyl Underbody Coating Bronze is a solvent cutback wax/asphaltic base, corrosion preventive. It is especially suitable to be applied to the underbody of vehicles. Tectyl Underbody Coating Bronze cures to a bronze colored, resilient, tough and abrasive resistant film.
Benefits and application considerations
- Superior Protection At the recommended DFT, the water resistance and displacement provide extraordinary protection against stone chipping and corrosion.
- Multi-functional Tectyl Underbody Coating can be applied on many different vehicles, such as cars, trucks, busses, campers, but also trailers and caravans.
- Processing Tectyl Underbody Coating Bronze is an easy to apply, elastic, protective underbody coating.
- Multiple substrates The underbody coating can also be used on different substrates, such as the wooden underside of campers or caravans.
Technical characteristics
- Carrier
- Solvent
- Recommended Dry Film Thickness — Over metal profile
- 250 µm
- Corrosion — ISO 9227 NSS (min. days)
- 40 days
- Humidity — Humidity; 100 % RH; @ 40°C; ISO 6270-2 CH (Q-Panels, Type R, ASTM A1008)
- 100 days
- Protection Indoor — (min. months)
- 36 months
- Protection Outdoor — (min. months)
- 21 months
Surface preparation
The maximum performance of Tectyl Underbody Coating Bronze can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale. CorPro recommends a substrate temperature of 10-35 °C at the time of product application. Avoid direct contact of the product with PVC due to possible material incompatibility.
Application
Tectyl Underbody Coating Bronze gives a maximum performance when it is sprayed at an ambient and product temperature of 10-25 °C. Shake the can well before use and spray at a distance of approximately 30 cm from the surface.
Tectyl Underbody Coating Bronze is fast-drying, and this can cause ‘pin-holing’ when applied too thick at once. It is advised to spray one layer per pass, wait for 2 to 3 minutes and then spray another layer. Continue like this until the required film thickness has been obtained.
Removal
Tectyl Underbody Coating Bronze can be removed in the wet phase with Tectyl Biocleaner, Tectyl 150 or low-pressure steam. If dried and cured Tectyl Underbody Coating Bronze can be removed with Tectyl Biocleaner or Tectyl 150.
Check the current official Technical Data Sheet and Safety Data Sheet before purchase or use. Coapsys can advise on product selection and application equipment.