Technical and safety information
- Carrier
- Solvent
- Chemical base
- Caucho y resina
- Colour
- Negro
- Pack format
- Consultar formatos disponibles
- Minimum order
- Consultar
For current hazard statements, precautions and transport information, consult the official English Safety Data Sheet before purchase or use. This page is not a substitute for the product label.
Documents
Technical Data Sheet (English) Application guide Safety Data Sheet (English)Technical documents are served by Coapsys from the official Tectyl Europe source.
TECTYL 190 Black is a black colored, solvent cutback, rubber/resin based corrosion preventive compound. TECTYL 190 Black is fast drying, has sound deadening properties and can be painted over. TECTYL 190 Black is recommended for the protection against corrosion and abrasive damage of ferrous metals and the underbodies of autos, trucks, trailers, etc. TECTYL 190 Black cures to a black, firm, resilient, tough film.
Benefits and application considerations
- Strong and Elastic protection Tectyl 190 Black creates a strong and elastic layer to prevent stone chipping on your vehicle.
- Overcoatable Tectyl 190 Black is overcoatable, so your vehicle keeps looking great.
- Processing Tectyl 190 Black is available in a vacuum can for easy application.
Technical characteristics
- Carrier
- Solvent
- Recommended Dry Film Thickness — Over metal profile
- 250 µm
- Corrosion — ISO 9227 NSS (min. days)
- 40 days
- Humidity — Humidity; 100 % RH; @ 40°C; ISO 6270-2 CH (Q-Panels, Type R, ASTM A1008)
- 100 days
- Protection Indoor — (min. months)
- 36 months
- Protection Outdoor — (min. months)
- 21 months
- Gravel-o-Meter (Stone chip) Test SAE-J-400
- 4A - 4B
Surface preparation
The maximum performance of Tectyl 190 Black can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale. CorPro recommends a substrate temperature of 10-35 °C at the time of product application.
Application
Tectyl 190 Black is formulated to be used as supplied. It is recommended that the ambient and product temperature be 10-35°C at the time of product application. Tectyl 190 Black can be applied by airless spray, vacuum spray guns or pressure can spray guns. Details on application can be found in the application chart.
Removal
Tectyl 190 Black is not intended for removal. In the wet phase Tectyl 190 Black can be removed with Tectyl 150 or low-pressure steam. If dried and cured Tectyl 190 Black can not be removed.
Check the current official Technical Data Sheet and Safety Data Sheet before purchase or use. Coapsys can advise on product selection and application equipment.