Technical and safety information
EU business customers with a validated VAT number can pay for the product and estimated shipping together at checkout. Shipping is 10% of the merchandise subtotal before VAT; dispatch follows destination-language safety documentation and chemical transport checks.
- Carrier
- Solvent
- Chemical base
- Caucho y resina
- Colour
- Negro
- Pack format
- Aerosol 500 ml
- Minimum order
- Case of 12 units
For current hazard statements, precautions and transport information, consult the official English Safety Data Sheet before purchase or use. This page is not a substitute for the product label.
Documents
Technical Data Sheet (English) Safety Data Sheet (English)Technical documents are served by Coapsys from the official Tectyl Europe source.
Tectyl Stone Chipping Black is a black colored, solvent cutback, rubber/resin-based corrosion preventive. The product is fast drying, has sound deadening properties and can be painted over. Specially developed to protect the underbody of cars, trucks, trailers, and other vehicles against corrosion and abrasive damage. Tectyl Stone Chipping Black cures to a black, firm, resilient, tough abrasive resistant film.
Benefits and application considerations
- Strong and elastic protection Tectyl Stone Chipping Black will protect against corrosion and creates a strong and elastic layer to prevent stone chipping on your vehicle.
- Overcoatable Tectyl Stone Chipping Black is overcoatable, which keeps vehicles looking great.
Technical characteristics
- Carrier
- Solvent
- Recommended Dry Film Thickness — Over metal profile
- 250 µm
- Corrosion — ISO 9227 NSS (min. days)
- 20 days
- Humidity — Humidity; 100 % RH; @ 40°C; ISO 6270-2 CH (Q-Panels, Type R, ASTM A1008)
- 42 days
- Protection Indoor — (min. months)
- 18 months
- Protection Outdoor — (min. months)
- 12 months
- Gravel-o-Meter (Stone chip) Test SAE-J-400
- 4A - 4B
Surface preparation
The maximum performance of Tectyl Stone Chipping Black can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale. CorPro recommends a substrate temperature of 10-35 °C at the time of product application.
Application
Tectyl Stone Chipping Black gives a maximum performance when it is sprayed at an ambient and product temperature of 10-25 °C. Shake the can well before use and spray at a distance of approximately 30 cm from the surface.
Tectyl Stone Chipping Black is fast-drying, and this can cause ‘pin-holing’ when applied too thick at once. It is advised to spray one layer per pass, wait for 2 to 3 minutes and then spray another layer. Continue like this until the required film thickness has been obtained.
Removal
Tectyl Stone Chipping Black can be removed in the wet phase with Tectyl Biocleaner, Tectyl 150 or low-pressure steam. If dried and cured Tectyl Stone Chipping Black can be removed with Tectyl Biocleaner or Tectyl 150.
Check the current official Technical Data Sheet and Safety Data Sheet before purchase or use. Coapsys can advise on product selection and application equipment.