Technical and safety information
Online Tectyl checkout is currently configured for Spain. For deliveries elsewhere in Europe, contact Coapsys to confirm availability and shipping before ordering.
- Carrier
- Solvent
- Chemical base
- Según ficha técnica oficial
- Colour
- Transparente
- Pack format
- Aerosol 500 ml
- Minimum order
- Case of 12 units
For current hazard statements, precautions and transport information, consult the official English Safety Data Sheet before purchase or use. This page is not a substitute for the product label.
Documents
Technical Data Sheet (English) Safety Data Sheet (English)Technical documents are served by Coapsys from the official Tectyl Europe source.
Tectyl Multipurpose Transparent is a solvent cutback, resin based, transparent, corrosion preventive. It has good water displacing properties and can be used as a versatile corrosion protective for a wide variety of applications on ferrous and non-ferrous metals: automotive, marine, household and Industrial like tools, chromium-plated parts (wheels of bicycles). Tectyl Multipurpose Transparent provides special protection to industrial and auto electrical wiring and contacts such as ignition coils, spark plugs wires and terminals. Tectyl Multipurpose Transparent cures to a hard, transparent and colorless film.
Benefits and application considerations
- Superior Protection At the recommended DFT Tectyl Multipurpose Transparent will protect against corrosion.
- Non-conducting The special nonconductive formulation makes Tectyl Multipurpose Transparent the ideal product to protect wiring in cars and industrial applications.
- Processing Tectyl Multipurpose Transparent is easy to apply and easy to remove, when no longer needed.
- Economical With a Dry Film Thickness of only 45 microns, Tectyl Multipurpose Transparent can protect a big surface with just a little amount of the product.
Technical characteristics
- Carrier
- Solvent
- Recommended Dry Film Thickness — Over metal profile
- 50 µm
- Humidity — Humidity; 100 % RH; @ 40°C; ISO 6270-2 CH (Q-Panels, Type R, ASTM A1008)
- 75 days
- Protection Indoor — (min. months)
- 36 months
- Protection Outdoor — (min. months)
- 6 months
Surface preparation
The maximum performance of Tectyl Multipurpose Transparent can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale. CorPro recommends a substrate temperature of 10-35 °C at the time of product application.
Application
Tectyl Multipurpose Transparent gives a maximum performance when it is sprayed at an ambient and product temperature of 10-25 °C. Shake the can well before use and spray at a distance of approximately 30 cm from the surface.
Tectyl Multipurpose Transparent is fast drying, and this can cause ‘pin-holing’ when applied too thick at once. It is advised to spray one layer per pass, wait for 2 to 3 minutes and then spray another layer. Continue like this until the required film thickness has been obtained.
Removal
Tectyl Multipurpose Transparent can be removed in the wet phase with Tectyl Biocleaner, Tectyl 150 or low-pressure steam. If dried and cured Tectyl Multipurpose Transparent can be removed with Tectyl 150.
Check the current official Technical Data Sheet and Safety Data Sheet before purchase or use. Coapsys can advise on product selection and application equipment.