Technical and safety information
Online Tectyl checkout is currently configured for Spain. For deliveries elsewhere in Europe, contact Coapsys to confirm availability and shipping before ordering.
- Carrier
- Wax
- Chemical base
- Cera
- Colour
- Ámbar
- Pack format
- Drum 20 L
- Minimum order
- 1 envase
For current hazard statements, precautions and transport information, consult the official English Safety Data Sheet before purchase or use. This page is not a substitute for the product label.
Documents
Technical Data Sheet (English) Application guide Safety Data Sheet (English)Technical documents are served by Coapsys from the official Tectyl Europe source.
Tectyl 210-R is an amber colored, solvent cutback, wax base, thixotropic corrosion preventive compound. Tectyl 210-R is designed for protection at factory level of enclosed boxes, seams, joints and other creviced locations of vehicles, susceptible to corrosion. Tectyl 210-R cures to a semi-hard, waxy, light amber colored, translucent slightly tacky film.
Benefits and application considerations
- Excellent penetration Tectyl 210-R penetrates in all small seams and joints, protecting creviced locations against corrosion.
- Economical solution With the thin layer of only 50 microns a large area can be protected against corrosion.
- Suitable for OEM and aftermarket use Tectyl 210-R is suitable to be applied at the manufacturing site as well as in the aftermarket. This makes Tectyl 210-R a flexible and attractive solution against corrosion.
Technical characteristics
- Carrier
- Wax
- Recommended Dry Film Thickness — Over metal profile
- 50 µm
- Corrosion — ISO 9227 NSS (min. days)
- 21 days
- Humidity — Humidity; 100 % RH; @ 40°C; ISO 6270-2 CH (Q-Panels, Type R, ASTM A1008)
- 100 days
- Protection Indoor — (min. months)
- 48 months
Surface preparation
The maximum performance of Tectyl 210-R can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale. CorPro recommends that the metal substrate temperature is 10-35 °C at the time of product application.
Application
Tectyl 210-R is formulated to be used as supplied. It is recommended that the ambient and product temperature be 10-35 °C at the time of product application. Do not dilute Tectyl 210-R. Incorrect dilution will affect film thickness, drying time and product performance. Tectyl 210-R can be applied by low pressure air spray technique. Details on application can be found in the application chart.
Removal
Tectyl 210-R can in the wet phase be removed with Tectyl Biocleaner, Tectyl 150 or low-pressure steam. If dried and cured the film of Tectyl 210-R can be removed with Tectyl Biocleaner or Tectyl 150.
Check the current official Technical Data Sheet and Safety Data Sheet before purchase or use. Coapsys can advise on product selection and application equipment.