Technical and safety information
The manufacturer's English SDS advises against private or household use of this reference. For delivery to other EU countries, checkout is limited to professional buyers with a validated EU VAT number. Dispatch requires destination-language safety documentation and chemical transport checks.
- Carrier
- Water
- Chemical base
- Base acuosa
- Pack format
- Drum 20 L
- Minimum order
- 1 envase
CLP hazard and safety information
English SDS revision: 2025-11-16
Use restriction: The manufacturer's SDS advises against private or household use.
Signal word: Warning
Hazard statements
- H319: Causes serious eye irritation.
Precautionary statements
- P264: Wash thoroughly after handling.
- P280: Wear eye protection/face protection.
- P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
- P337+P313: If eye irritation persists: Get medical advice/attention.
This excerpt follows section 2.2 of the linked English SDS. Consult the full SDS and the product label before use. Request the official SDS and label in your destination country's language before dispatch; include the Tectyl reference, destination country and order number.
Documents
Technical Data Sheet (English) Application guide Safety Data Sheet (English)Technical documents are served by Coapsys from the official Tectyl Europe source.
Tectyl Biocleaner is a water based, biodegradable cleaner intended for removal of synthetic, animal, vegetable and mineral oils, greases and coatings. Tectyl Biocleaner can be used as to remove Tectyl corrosion preventative coatings. Tectyl Biocleaner leaves a clean and smooth surface.
Benefits and application considerations
- Excellent performance Tectyl Biocleaner gives an excellent clean surface.
- Economical The highly concentrated Tectyl Biocleaner is economical in use.
- Safe to use Tectyl Biocleaner is biodegradable.
- Widely applicable Tectyl Biocleaner can be used in high pressure cleaning, tank-cleaning and floor scrubbers.
Technical characteristics
- Carrier
- Water
- Protection Indoor — (min. months)
- n.a
- Protection Outdoor — (min. months)
- n.a
Surface preparation
The maximum performance of Tectyl Biocleaner can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale. CorPro recommends a substrate temperature of 10-35 °C at the time of product application.
Application
Tectyl Biocleaner is intended to be diluted in water (25%) for removing wax and oil based Tectyl layers up to the use of pure product (100%) with other layers or contaminated areas. For dilution demineralized or normal tap water can be used.
The dilution and the exposure time depend on the nature and degree of pollution, the processing temperature and the chosen application method.
Apply Tectyl Biocleaner, let it soak for several minutes and then rinse thoroughly with clean water. When necessary, repeat the treatment and/or increase the dosage. The use of hot water and mechanical support (such as pressurized water) will increase efficiency.
When applying for the first time it is advised to test the product prior to use to prevent non intended paint removal. Applicable concentration depends on the application method and application area.
Check the current official Technical Data Sheet and Safety Data Sheet before purchase or use. Coapsys can advise on product selection and application equipment.